WiFiLabelSGD settings
These are the settings keys the printer stores. Read one before you change it.
- appl.name
Reads the application firmware name.
- device.friendly_name
Reads or sets the name the printer shows to people and discovery tools.
- device.languages
Selects whether the printer parses ZPL, EPL, or a hybrid mode.
- device.reset
Restarts the printer through an SGD do command.
- device.restore_defaults
Restores factory defaults through an SGD do command.
- device.unique_id
Reads the printer unique id. It cannot be set.
- ezpl.label_length_max
Maximum label length the sensor will search, in dots.
- ezpl.media_type
Selects continuous, gap/notch, or mark media.
- ezpl.print_method
Selects direct thermal or thermal transfer.
- ezpl.print_width
Print width in dots.
- ezpl.tear_off
Tear-off present adjustment in dots.
- head.resolution.in_dpi
Reads the printhead resolution in dots per inch.
- interface.network.active.ip_addr
Reads the IP address of the active network interface.
- media.darkness
Gets or sets absolute darkness on the 0 to 30 scale.
- media.printmode
Selects tear-off, peel, rewind, cutter, or applicator behavior.
- media.sense_mode
Selects gap, bar, or continuous sensing on firmware that exposes this key.
- media.speed
Gets or sets print speed in inches per second.
- media.type
Older media-type key. Confirm the spelling on the printer.
- media.width_sense.enable
Turns automatic label-width sensing on or off.
- odometer.total_print_length
Reads the lifetime print-length odometer.
- print.tone
Link-OS darkness, on the same idea as a 0 to 30 burn level.
- zpl.relative_darkness
Relative darkness in tenths, matching the relative ZPL command.