WiFiLabeldevice.reset
Restarts the printer through an SGD do command.
Device reset is an action, not a stored value. Sending do runs a restart similar to a power cycle. Jobs in memory are lost. Use it after a language or network change that will not apply until boot, not as a way to clear a paper fault. The setter refuses a normal set, because this key is not a setvar. The do helper also requires an explicit confirm flag. Wait for the printer to enumerate again, then read identification before the next label.
Syntax
! U1 do "device.reset" ""
| Type | string |
|---|---|
| Range | |
| Access | do |
Example
See also
Source: Zebra documentation